Safe method of “fixing off” wall frames
Easy “walk in to” design
Can be used as a finishing / bracing table
Presents the frames at a safe, easy work height
In built safety features to prevent unexpected movement in cases of air removal or component failure
Minimises operator bending and reaching
TILT TABLE
The Pryda Tilt Table has been developed to remove the continual bending and reaching required
when fitting off noggins and finishing prefabricated wall frames.
The table allows wall frames to be easily moved across it to the required position for finishing.
Once there, the bench rotates to an angle that allows the operator to safely and easily finish the
frame without undue bending.
This system’s easy, simple controls ensures that untrained or inexperienced operators will require
minimal or no training in its use. Installation can be finished in approximately one to two hours.
SPECIFICATIONS
| Dimensions | ||
| Overall dimensions (std unit) | – Length | 6070mm |
| – Width (when fully opened) | 2900mm | |
| Maximum wall frame length | 6m | |
| Work height (not tilted) | 920mm | |
| Tilt angle | Variable to 45 degrees | |
| Base rail height (when fully tilted) | 100mm | |
| Weight (approx) | 350kg | |
| Installation requirements | ||
| Power | Nil | |
| Air | 5cfm @ 100psi | |
| Data | Nil | |
| Foundation | Level, sound concrete floor in both directions |
RELATED PRODUCTS
- Pryda Production Viewer
- Manual outfeed
- Automated outfeed