Reinforces top plates and common stud that have been compromised by large holes commonly drilled through for services. i.e. plumbing pipe, electrical cabling.
USES
Alternative Solution to NZS3604 to Section 8, Clause 8.7.5 Holes in plates.
Pryda Frame Fix (PFF2) is intended to re-instate the structural integrity of SG8 90 x 45mm wall frame top plate (including a top plate packer if used) or common wall stud that have had a service hole of no greater than 60mm diameter drilled through its centre.
When Pryda Frame Fix (PFF2) is installed in accordance with this document, the top plates in the section that the Frame Fix is installed can be considered structurally adequate as originally designed in accordance with NZS3640.
Frame fix is suitable for use on 90mm wide frames ONLY.
Pryda Frame Fix (PFF2) is to be installed internally in areas within the building envelope that are kept permanently dry and suitable for “closed” environment as defined in NZS 3604:2011 Table 4.1.
FEATURES
STRONG: Stiffens the top plate for areas in the region of the penetrations.
EASY: Quick installation to top plate by using Pryda self-drilling screws.
VERSATILE: Suitable for both single & double top plates (35mm or 45mm). Can be installed before or after service pipe penetration.
Installation
For application and design information, refer to the product data sheet.
Pryda Frame Fix
| Product Code | Size | Pack Quantity |
|---|---|---|
| PFF2 | 240 x 34 x 31mm. Max hole diameter 60mm | 10 sets (with screws) |
| PFF (old version, no longer available) | 240 x 88 x 35mm. Max hole diameter 60mm | 10 |